CTI On-Board IS 250F - SERVICE

Consumable parts vary with model type. 

Brooks CTI-Cryogenics On-Board IS 250F - Scope of Work

One year warranty repair service.

PTB Sales will perform the following:

1. Incoming Inspection

• Attach work order to cryopump
• Picture taken of cryopump's mechanical configuration
• S/W version recorded on work order

2. Complete teardown and disassembly of the pump

3. All parts are inspected and cleaned

• Aqueous high pressure parts washer

4. Parts are dimensionally evaluated

5. Cryopump Rebuild

• Vacuum Rebuild
  • Replace 15K array
  • Replace 80K condensing array
  • Replace radiation shield
  • Replace 1st and 2nd stage temperature sensors and wires
  • Replace O-rings in rough valve and purge valve
  • Replace all hardware
  • Verify / replace heater operation
  • Verify / replace vacuum vessel
• Refrigerator Rebuild
  • Replace O-rings, seals and bushings in the cross head assembly
  • Replace the rocker valve springs, lock nuts and gland
  • Replace supply and return aeroquip connectors
  • Replace dowel pin for the displacer cap nut
  • Inspect / replace scotch yoke
  • Replace valves and valve stems
  • Inspect / replace crankshaft and drive assembly
  • Inspect / replace rocker arms / assembly
• Drive Motor Rebuild
  • Replace bearings
  • Replace O-rings
  • Inspect / replace motor shaft

6. Module Rebuild

• Customer data uploaded into database
• Battery replaced
• PCB's inspected
• Inspect / replace power components > 5 years old
• Inspect / replace I/O connectors (RS-232, USB, HDDB15, power)

7. Sub Assembly Test

• Module test
• Motor test
• Refrigeration load test
• Set / test timing of exhaust and inlet valves
• Verify diode characterization

8. Final Test

• Vacuum sided leaked checked to 1 x 1E^-9 sccm
• Helium circuit leaked checked to 5 x 10E^-8 sccm
• Perform two full regenerations
  • Time to reach <17K verified
  • Time to reach <= 12K (bottom out temperature) verified
  • Run pump in temperature control at 100K for 30 minutes
• Runtime hours reset to zero
• Fast and full regeneration history cleared

9. Final Quality Control Check List

• Picture taken of cryopump’s as shipped configuration
• Final test report attached to cryopump
• Protective covers installed on all vacuum flanges
• Protective covers installed on power and I/O connectors
• Package with accordance with DOT Standards

View our inventory of rebuilt Brooks CTI On-Board IS, On-Board, and Cryo-Torr cryopumps.

This product has been refurbished by PTB Sales, Inc. PTB Sales is not affiliated with Brooks Automation, Inc., the Original Equipment Manufacturer. In some cases, PTB Sales uses processes and parts that are different from those used by the OEM, and the OEM expressly disclaims any warranty obligations with respect to this refurbished product.

Request an RMA  Return Material Authorization

Procedures for shipping used equipment to PTB Sales:

• Seal off the exhaust and inlet of the pump.
• Attach our pump declaration form to the equipment to declare what contaminants the equipment has been exposed to.

There is a $300 Evaluation Fee. This gets applied to the cost of repair.

Questions? Please call our toll free number at 866-332-0500 or send an e-mail to our sales team!

This product has been refurbished by PTB Sales, Inc. PTB Sales is not affiliated with Brooks Automation, Inc., the Original Equipment Manufacturer. In some cases, PTB Sales uses processes and parts that are different from those used by the OEM, and the OEM expressly disclaims any warranty obligations with respect to this refurbished product.